What is the emergency method of oil supply failure?

What is the emergency method of oil supply failure? Oil pump manufacturers for you to introduce:

(1) emergency method for oil pump failure

If the oil pump is damaged and unable to supply oil, direct oil supply method can be adopted. Take a properly sized plastic or iron bucket and fill it with diesel fuel. Remove the crude diesel filter and insert it directly into the oil pipe of the oil pump. However, it should be noted that oil drums should not be placed near the exhaust pipe or exhaust outlet.

(2) emergency method of radiator leakage

If the radiator is leaking, open the radiator water cover first to reduce the temperature and pressure and alleviate the leakage. Stick sticky rice group, rice group and other sticky food in leaking place next, can temporarily prevent or reduce water leakage.

Damaged radiator core can be used to flatten the damaged copper pipe with needle-nosed pliers until it is watertight. If there is adhesive repair glue can be used to solve the leakage: put the water in the box clean, remove oil and rust on the surface of the leakage, wipe clean with "two-in-one" glue on the surface of the leakage evenly, apply again half an hour later, after two hours can test the adhesive repair situation, 3 hours to achieve the maximum strength.

(3) emergency method for sudden burst of radiator inlet pipe

Hoses to engine radiators age and break easily after long use. If the radiator hose ruptures during the drive, the hot water spurts out in a cloud of steam from under the engine bonnet. This phenomenon should be found immediately to find a safe place to park, and then take emergency measures to solve.

Under normal circumstances, the joint of radiator inlet hose is most prone to crack and leakage, then you can use scissors to cut off the damaged parts, and then the hose is re-inserted into the radiator inlet connector, and clamp or wire clamp tight. If the break is in the middle of the hose, use tape to tie the leak. Clean the hose before winding. After the leaking part is dry, wrap the tape around the leaking part of the hose. Because of the high water pressure in the hose when the engine is working, the rubber cloth should be tightened as much as possible.

If you don't have tape on hand, wrap plastic around the tear, then cut strips out of old cloth and wrap them around the hose. Sometimes the hose has a large tear and may leak after winding. Open the radiator cover and reduce the pressure in the channel to reduce leakage.

Take the above measures, the engine speed cannot be too high, to try to hang high speed block driving, driving often pay attention to the coolant thermometer pointer position, found that the coolant temperature is too high to stop cooling or add coolant. In addition, it is necessary to go to the repair shop as soon as possible to replace the new water pipes.