Basic introduction of oil pump coupling steel sheet manufacturers

Time：2020-03-11

Oil Pump coupling steel sheet manufacturers basic introduction, high-pressure oil pump uses and installation sequence, progress fuel pressure, low-pressure radiation, reach atomization consequences, the main use of high-pressure oil pump is as a Jack, header, extruder, flower machine and other hydraulic assembly power source. ASSEMBLY SEQUENCE OF HIGH-PRESSURE OIL PUMP: in the process of installation of low-pressure oil pump, in order to avoid debris falling into the machinery, the unit should cover all the holes. The unit is placed on a foundation with embedded anchor bolts and paired wedges are used for calibration between the base and the center of the foundation. The alignment of the pump shaft and the electromechanical shaft can be corrected to an error of 0.1 mm in the outer circle of the coupling. The clearance between the two coupling planes should be ensured to be 2-4 mm, the clearance should be average and the tolerance should be 0.3 mm. After connecting the pipe and confirming the transfer direction of the motor, then connect the coupling, and continue to revise the axis of the Qi Xin Fang. In the unit after 2 ~ 3 hours of trial operation, do the final reflection, if there are no bad signs, you feel that the assembly pass. During the trial operation, reflect the temperature and vibration environment of the bearing below: Loosen the coupling, separate it on the pump shaft and the base of the electric oil pump with the degree instrument, adjust the unit degree through adjusting the wedge, and tighten the anchor bolt properly, to keep them from moving. In order to avoid debris in the pipeline into the pump, the newly assembled pipeline should be installed in the pump rubber filter, its useful cross-section should be larger than the suction pipe cross-section of 2 ~ 3 times. Xingtai Beilong internal combustion engine Parts Co. , Ltd. (formerly Julu Beilong fuel injection pump parts factory) was established in 1999, located in Julu Houluzhai industrial zone, Xingtai, Hebei Province. Now with Heze Huaxing Fuel Injection Equipment Co. , Ltd. , Longhua Auto Parts Co. , Ltd. , Jiangsu Sihong Fuel Injection Equipment Co. , Ltd. . Xinya greenball electronic fuel injection nozzle Co. , Ltd. , Nantey test equipment plant, Hengyang Nanyue electronic fuel injection nozzle Co. , Ltd. , Changzhou Borui fuel injection nozzle Co. , Ltd. . At the same time the production of railway locomotive parts, Mine Parts, ship parts, construction machinery parts. In addition to the current production of products, we can also be customized according to customer requirements of a variety of fuel injection pump accessories. The monthly output can reach 6 million pieces, and the area of the factory is more than 7,800 square meters.