Purpose of high pressure oil pump

High pressure oil pump repair kit manufacturer

The main purpose of high pressure oil pump is as the power source of hydraulic equipment such as jacks, upsetters, extruders and tie - hua machines. The equipment of the high-pressure oil pump is as follows: in the process of the high-pressure oil pump of the equipment, in order to avoid sundries falling into the machine, all the holes of the unit should be covered. Set the unit on the foundation with embedded anchor bolts, between the base and the foundation, with a pair of wedge pads for correction. Calibration of concentricity of pump shaft and motor shaft, on the outer circle of coupling shaft avenue, tolerance of error 0.1mm; 2 ~ 4 mm should be guaranteed in the open space of the two coupling plane, (small pump to take a small value) the open space should be uniform, tolerance 0.3 mm. After connecting the pipe and determining the rolling direction of the motor, connect the coupling and check the concentric shaft again. 2 ~ 3 hours after the unit practice and trial operation, the final inspection, if there is no bad phenomenon, it is considered qualified equipment. During the test run, check the temperature and vibration of the bearing as follows: loosen the coupling shaft, put the level gauge on the pump shaft and base of the electric oil pump, adjust the wedge pad to adjust the level of the unit, and properly tighten the high-pressure oil pump to prevent moving. In order to avoid debris in the pipeline into the pump, for the pipeline of new equipment, the pump glue should be equipped with a filter, its useful section should be greater than the suction pipe section of 2 ~ 3 times.